[News]

News: Glomation introduced new wireless ready low cost GESBC-9260S

[gurtlerc]

gurtlerc

gurtlerc

Show gurtlerc's last posts.

Show general stats for gurtlerc.

• 
• Super Hero
• Posts: 9

Hi,

The Web site says that there is support for Windows CE but I can't find any information about how I can load it up. Do you have any instructions on how this might be done?

Regards,

Chris

[admin]

admin

admin

Show admin's last posts.

Show general stats for admin.

• 
• Administrator
• Super Hero
• Posts: 339

The GESBC-9260 is a simplified version of the Atmel 9260EK board.  The same install and programming procedure for the Atmel EK board can be used for the GESBC-9260.

[gurtlerc]

gurtlerc

gurtlerc

Show gurtlerc's last posts.

Show general stats for gurtlerc.

• 
• Super Hero
• Posts: 9

Thanks, but there is a lot more to it than what you have mentioned in that response. I can find no literature on the Atmel 9260EK board and no instructions on how an image might be built for it. Then there is the issue of how to load it into the flash. If you have any information that might be useful then that would help.

[mmenti]

mmenti

mmenti

Show mmenti's last posts.

Show general stats for mmenti.

• 
• Super Hero
• Posts: 20

Thanks, but there is a lot more to it than what you have mentioned in that response.

I guess that most people here in the forum are using Linux - not WinCE. You can find some WinCE informations directly at atmel's homepage. The board name is "at91sam9260-ek". Or Just google with this board name.